RepRap Stores

This a Ver 2.2 Assembled Generation 3 Extuder  Controller for the the Rep rap 3D Printer

(wiki page and files)
[reprap.org]

This board has been modified from the Makerbot version to be just for the RepRap and hase been reduced in physical size.

We did change the screw down terminal used for the temp connection to a 2 pin .1" jumper terminal.

We also used higher amp mosfets in a Dpak configuration (almost all standard mosfets in a Dpak will work on this board, so you can select values which are correct for your use, if you are building your own.

We added an additional footprint for the processor (like on the Mainboard, and for the same reasons) and we added a footprint to the full bridge control chip(s).